SENA Promi-MSP User Guide - Manual (Page 53)

53
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
DISC <idx>
: Promi-MSP may DISCONNECT forcibly by DISC command, giving INDEX
value in LIST command.
Ex.: LIST
0|0|5000|00:0B:53:00:00:8A|SDv3b-00008A|0|0
+OK
DISC 0
+OK
LIST
+OK
LINKTO <timeout>
: When a Bluetooth device is disconnected by turning off its power, Promi-
MSP has default time out of 20 seconds in finally closing the connection.
You may assign the time out from 1 second up to 30 seconds.
Ex.: LINKTO 20
+OK
MAXDT <number of max. connections>
: To assign maximum Bluetooth devices concurrently connectable to
Promi-MSP ™ . Default value is 7. Each additional USB extension
module adds up to 7 more Promi-MSP ™ connectable Bluetooth devices.
Ex.: MAXDT 7
+OK
PINQ <on|off> <interval> <length> <IAC>
: If PINQ (periodic inquiry) is ON, Promi-MSP will inquire nearby Bluetooth
devices periodically, by each <interval> seconds, for <length> time.
Inquired result can be checked by NGBRH command.
Note:
Promi-MSP normally acts as an acceptor. Do not use CONN command in
operating sequence as Promi-MSP will freeze during CONN operation.
If using with Promi-SD, please configure Promi-SD as Mode 1 and make
it initiate connection to Promi-MSP.