Draw-Tite 30095 FIFTH WHEEL RAILS - Manual (Page 13)

30095N 1/30/12 REV. H
©2012 Cequent Performance Products, Inc. PRINTED IN XXX 13
F-350 super Duty long bed
frame shown
1/4 2
1/4 2
*
* Optional weld pattern. Typical for all 4
brackets.
Front of
Vehicle
Bed sill
Front of Vehicle
30 3/16 ” Long Bed
& Short Bed
Measure from Rear Edge of
truck bed to rear edge of base
rail.
Rear Edge of
Truck Bed
CAUTION!
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
2005-CURRENT FORD F-250, F-350 & F-450 SUPER DUTY (NOT CAB-CHASSIS)
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc. Cequent
Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the responsibility of the
installer to prevent damage due to installation.
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4 ” between
parallel rows of spot welds where the bed sill sets.
2. It may be necessary to move the brake cable hanger bracket into another hole just rearward from its present
location.
Angled Bracket
Straight Bracket
Straight Bracket
Angled Bracket
Front of
Vehicle
PASSENGERS SIDE
DRIVERS SIDE
Bed sill
Hitch center approximately
Over the axle center.