Draw-Tite 30095 FIFTH WHEEL RAILS - Manual (Page 16)

30095N 1/30/12 REV. H
©2012 Cequent Performance Products, Inc. PRINTED IN XXX 16
Axle Center
1/4 1.5-3
1/4 2
*
1/4 2
1/4 2
*
* Optional weld pattern
Drivers side shown
Straight bracket
Angled bracket
King Pin Centered approx. 1- 1/4”
forward of Axle Center
Front of Vehicle
30 7/16”
Measure from Rear Edge of
truck bed to rear edge of
base rail.
Rear Edge of
Truck Bed
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
CAUTION!
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
2000-06, TOYOTA TUNDRA (STANDARD CAB LONG BED ONLY)
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Cequent Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately
the responsibility of the installer to prevent damage due to installation.
2000-06, TOYOTA TUNDRA long: (Approx. over the axle)
With Fifth wheel assembly in the bed of the truck. Position the rear rail 30 7/16” from rear edge of truck bed. Attach the left and right
angled frame brackets to the rear Fifth wheel rail. Note: The left and right angle bracket can be mounted on either side of the truck if
needed. Then attach the frame bracket to the front Fifth wheel rail.
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4
” between
parallel rows of spot welds where the bed sill sets.
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
Left, right angle and frame
brackets maybe place where
ever brackets fits best.