Draw-Tite 30095 FIFTH WHEEL RAILS - Manual (Page 7)

30095N 1/30/12 REV. H
©2012 Cequent Performance Products, Inc. PRINTED IN XXX 7
Front of
Vehicle
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
Rear Edge of
Truck Bed
Measure from rear edge of
truck bed to rear edge of
base rail
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Cequent Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately
the responsibility of the installer to prevent damage due to installation.
CAUTION!
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
Chevrolet & GMC 73 to 87 & 73 to 92 4-
door (34” Straight, with Inside Shock Absorbers)
Long Bed =33 3/16”
Short Bed =23 3/16”
1/4 1.5-3
1/4 2
*
* Optional weld
pattern
Drivers side of 1/2 ton Chevy Long Box Shown
King Pin Center approx.
Long bed 3 1/2” & short
bed over the Axle Center
Axle Center
Bed Sill
Front of
Vehicle
Angled Bracket
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4 ” between
parallel rows of spot welds where the bed sill sets.
Center
Hole
Center
Hole
Straight Bracket
Left, right angle and frame
brackets maybe place where
ever brackets fits best.
1/4 2
1/4 2
*