Comfort Stat CDT901 - Manual (Page 47)

CDT900 Series Touchscreen Programmable Thermostata
CAUTION
Electrical Shock Hazard.
Can cause electrical shock or equipment damage.
Disconnect power supply before connecting wiring.
Wiring must comply with applicable codes, ordinances and regulations.
1.Wire Indoor Sensor to S1 and S2 terminals on the thermostat. For an example of general
wiring of IRS-1, see Fig. 28 to wire one sensor and 29 to wire multiple sensors.
2.Push excess wire back into the hole. Plug the hole
using nonhardening caulk, putty or insulation to prevent drafts from affecting performance.
3.Remove IRS-1 sensor cover.
4.Mount IRS-1 to the wall or junction box using the screws and anchors provided.
5.Level the IRS-1 for appearance only. Device functions correctly even when not level.
6.Install IRS-1 cover.
46