Replacing the top part of an actuator size 40mm – Burkert Type 1062 User Manual
Page 17
![background image](/manuals/329831/17/background.png)
17
Assembly
Type 1062
7.2
Replacing the top part of an
actuator size 40mm
note
the tightness of the actuator is not guaranteed when the
cover is removed.
▶ Prevent the projection of fluids into the actuator.
A
B
→
Remove the top part
of the actuator, "A",
by unscrewing it with
the spanner available
in accessories (item
number 639175).
→
Remove the top part
of the actuator rod,
"B", by unscrewing by
hand.
→
Screw the top part of
the actuator supplied
with the 1062 to the
actuator size 40mm,
and tighten it using the
spanner (item number
639175).
Fig. 5: Replacing the top part of the actuator size 40mm
7.3
fitting the position feedback to a
pneumatic actuator
note
the tightness of the actuator is not guaranteed when the
transparent cap is removed.
▶ Prevent the projection of fluids into the actuator.
the tightness of the position feedback is not guaranteed
when the cover is removed.
▶ Prevent the projection of fluids into the position feedback.
the position feedback may be damaged if a metal com-
ponent comes into contact with the electronics.
▶ Prevent contact of the electronics with a metal component (a
screwdriver, for example).
C
D
→
If the valve is fitted with an actuator
size 40mm, replace the top part of the
actuator. See chap. „7.2“
→
Unscrew the cone point set screw "C"
from the 1062 to unlock the dupli-
cation system "D" using a hexagonal
male spanner.
→
Carefully remove the duplication
system "D" from the housing of the
1062.
english