Burkert Type 8691 - Manual (Page 33)

33
Electricalinstallation24VDC
9.5.3 change assignment of the Top leDs (device status)
Danger!
risk of electric shock.
▶ Before working on equipment or device, switch off the power supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations for electrical equipment.
Procedure:
noTe!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the body casing, do not hold the actuator of the process valve but the
connection housing.
→
Unscrew the body casing (stainless steel) in a counter-clockwise direction.
Body casing
Connection housing
Actuator
Figure 25: Open control head
→
Using the jumpers, assign the required color to the Top LEDs.
Jumper for assignment of Top LEDs
ye gn
To
p
Bot
Bot
To
p IN 1
IN 2
24 V
Valve
+
-
+
-
ye gn
To
p
Bot
Bot
To
p
Jumper function:
You can set the color assignment of the end positions with
the jumpers.
You can indicate for each color whether it applies to the Top
(upper end position) or Bot (lower end position).
Figure 26: Assignment of the Top LEDs
english
Type 8691