Burkert Type 8035 - Manual (Page 17)

17
Installation
Type 8025/8035 /
Correct
flow direction
Incorrect
Correct Incorrect
Fig. 6: Air bubbles within the pipe
→
If necessary, use a flow conditioner to improve measurement
accuracy.
7.2.2. installation of the 8025 on the s020
fitting
2
1
3
4
5
6
→
Install the S020 fitting into the pipe
obeying the instructions in chap. "7.2.1"
→
Check that there is a seal on the fitting
and that it is not damaged. Replace the
seal if necessary.
→
Insert nut 3 on fitting 5.
→
Insert snap ring 2 into groove 4.
→
Check that seal 6 is correctly inserted on
the flow sensor.
→
Insert device 1 into the fitting.
If the mounting is correctly done the device
cannot be turned around anymore.
→
Hand lock the assembly with nut 3.
Fig. 7: Installation of the 8025 on the S020 fitting
English