Burkert Type 8035 - Manual (Page 18)

18
Installation
Type 8025/8035 /
7.2.3. installation of the se35 electronic
module onto the s030 sensor-fitting
1
2
3
→
Respect the installation
instructions contained
in the operating instruc-
tions of the fitting used.
→
Insert the electronic
module 2 into the S030
sensor-fitting.
→
Fix with a 30° rotation.
→
Tighten the side screw
3 to lock the elec-
tronic module to the
sensor-fitting.
Fig. 8: Installation of the SE35 onto the S030 sensor-fitting
7.3. installation of a panel version of
the 8025 flowmeter
install the panel version of the device in a cabinet with
a protection class at least ip54 to ensure a degree of
pollution 2 inside the cabinet.
→
To cut the opening in the cabinet door, use the supplied cutting
plan of the frontage of the electrical cabinet, respecting the
dimensions indicated in "Fig. 9".
95
80
76
50
95 80 76 50
Fig. 9: Dimensions [mm] of the electrical cabinet frontage cutting
plan
English