Installation and commissioning – Burkert Type 8035 User Manual
Page 49
49
Installation and commissioning
Type 8025/8035 /
9.
insTAllATion AnD
commissioninG
9.1.
safety instructions
Warning
risk of injury due to non-conforming operating.
Non-conforming operating could lead to injuries and damage the
device and its surroundings.
• The operators in charge of operating must have read and under-
stood the contents of this manual.
• In particular, observe the safety recommendations and intended use.
• The device/installation must only be operated by suitably trained
staff.
Warning
danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended use.
• The device / the installation must only be commissioned by suit-
ably trained staff.
• Before commissioning, set the K Factor of the fitting used. See
9.2.
operating levels of the device
The device has two operating levels: the Process level and the Con-
figuration level.
Table 4: Default settings of the device
function
default value
LANGUAGE
English
UNIT of the flow rate
L/min, 1 decimal
UNIT of the totalizers
L
Number of decimal positions 1
4 mA current output
0.000
20 mA current output
100.0
K FACTOR
51.20
FILTER
5
Value of a pulse (PU)
00.05
Unit of the pulse output
L
Relay 1-
40.0
Relay 1+
50.0
Relay 1 inverted
no
Relay 2-
80.0
Relay 2+
90.0
Relay 2 inverted
no
English