CONTREX M-Traverse - Manual (Page 133)

4 - 6
. . . . . . . .
0.0.0.0.0.0. 0.0.
1.1.1.1.1.1. 1.1.
2.2.2.2.2.2. 2.2.
3.3.3.3.3.3. 3.3.
4.4.4.4.4.4. 4.4.
5.5.5.5.5.5. 5.5.
6.6.6.6.6.6. 6.6.
7.7.7.7.7.7. 7.7.
8.8.8.8.8.8. 8.8
9.9.9.9.9.9. 9.9.
A.A.A.A.A.A. A.A.
b.b.b.b.b.b. b.b.
C.C.C.C.C.C. C.C.
d.d.d.d.d.d. d.d.
E.E.E.E.E.E. E.E.
F.F.F.F.F.F. F.F.
The lower LED display is blank and the upper LED display defaults
back to “Help” and the number “4” after the M–Traverse has completed
the display variations.
The M–Traverse automatically exits the test - go to the next test.
Press “Code Select” only if you want to exit diagnostics.
Annunciator Test #5- To Test the Discrete LED Indicator Display
To enter this test, press the “Status” key to increment (or the “Tach” key
to decrement) until the number “5” is visible on the right side of the
upper LED display.
Press “Enter” to start the test.
If they are functioning properly, the discrete LED indicator displays will
illuminate in this order:
Code Select
Status
Tach
Setpoint
Batch Count
Run
Control Enable
Lead Sync
At-Home
Alarm
The M–Traverse automatically exits the test - go to the next test.
Press “Code Select” only if you want to exit diagnostics.