CONTREX M-Traverse - Manual (Page 42)

2 - 27
CALIBRATION
Calibration matches the analog output of the M–Traverse with the analog input of the
motor drive. Calibration is accomplished in two steps. The first step is to set up the
motor drive. The second step is to calibrate the M–Traverse to the motor drive so that
the speed is adjusted to the maximum operating speed. The M–Traverse must be
properly installed prior to calibration. Refer to
Installation/Setup; Mounting and
Installation/Setup; Wiring .
Hazardous voltages.
Can cause severe
injury, death or
damage
to the equipment.
Make adjustments with caution.
DANGER