CONTREX M-Traverse - Manual (Page 155)

5 - 8
a Control Parameter (CP) or a Monitor Variable (MV) OR
to enter a value for a Control Parameter. Use the “Enter”
key after each entry. Use the “Clear” key to delete your
entry.
Open Loop A system that is controlled only by inputs without feedback.
Operating State The systems status, such as Run, F–Stop, or Jog, within a
mode of operation.
Output Monitoring DAC Output (MV-47)
Trim Output (MV-48)
Discrete Outputs - Group A (MV-56)
Discrete Outputs - Group B (MV-57)
Output A Direction See Appendix C; CP-91.
Output A Polarity See Appendix C; CP-92.
Output A Segment See Appendix C; CP-90.
Output B Direction See Appendix C; CP-94.
Output B Polarity See Appendix C; CP-95.
Output B Segment See Appendix C; CP-93.
Outputs Speed Command Out (J1 pins 8, 9, 10, 11)
Drive Enable (J1 pin 13)
Batch Done (J1 pin 14)
Alarm (J1 pin 15)
Profile Direction (J1 pin 16)
At-Home (J1 pin 17)
Output A (J1 pin 18)
Output B (J1 pin 19)
Auxiliary DC Power (J3 pin 1, 2)
Parameters Parameters are divided into two classifications; Control
Parameters (CP) and Monitor Variables (MV).
Parameter Code The numbered code that represents a Parameter.
Parameter Send Use the Parameter Send to change any of the M–
Traverse's Control Parameters in Serial Communications.
Parameter Value Default parameter values are pre-loaded in the factory,