CONTREX M-Traverse - Manual (Page 30)

2 - 15
Run (J4 pins 6,7)
When the Run input is momentarily
closed, the M–Traverse enters Run.
As a momentary input, Run is
internally latched and does not need
to be maintained by an operator
device.
NOTE: Close the F–Stop input prior
to entering Run.
Wait (J4 pins 7,8)
When the M–Traverse is in Run, it
checks the Wait input before it
proceeds with the next profile move
in either the forward or reverse
direction. If the Wait input is closed,
it will pause at the end of the profile
until the wait input opens.
Figure 2-16 Run
Figure 2-17 Wait
RUN
6
7
J4
Wait
8
7
J4