Luminex IS Version 2.3 - Manual (Page 41)

x
MAP Technology Luminex 2.3 Software
PN 89-00002-00-110 Rev. B 31
Acquisition Detail tab. When you click on the New Advanced Batch
button, the Options dialog box opens, where you enter information
about the batch, define bead events for the session, and define
commands for plate layout.
New Batch
Opens a dialog box in which you select a template to create a new
batch in the Luminex Batch Setup window.
New CAL Targ.
Opens the Update CAL Targets dialog box, in which you enter
information about the calibration microspheres you are using to
calibrate the system.
New CON Targ.
Opens the Update CON Targets dialog box, in which you enter
information about the control microspheres you are using to verify
system calibration.
New Lot
Opens the Open Template dialog box, from which you select a
template to which you want to add a lot or edit lot information.
Open Batch
1. The Open Batch command selected from the file menu or toolbar
opens the Open Batch Dialog box, from which you choose an
existing batch to use for acquisition.
2. The Open Batch command on the Analysis window allows you
to view data from a different batch.
Open Help
Opens the online help file.
Open Incomplete Batch
Opens the Open Run dialog box, in which you select a batch to
recover.
Open Multi-Batch
Opens the Open Multi-Batch dialog box, in which you select a multi-
batch to use for acquisition.
Pause
Pauses the command that the system is currently processing.
Previous Test
This command is found in the Analysis window. Use this command
to view the previously run test in the batch.
Prime
Removes air from the system’s fluidic pathways by drawing
Luminex xMAP Sheath Fluid from the sheath fluid container. You
do not need to supply solution in a plate. Priming takes
approximately one minute. This command should also be used as
part of the daily startup routine.