Micromod Micro-DCI: 53MT6000 Micro-Tools - Manual (Page 73)

53MT6000 INSTRUCTION MANUAL
Database Editor 57
7.4.7.3 SETPOINT Configurable Parameters
The control module SETPOINT parameters may be configured by clicking on the SETPOINT button. The
window shown in
Figure 7-12 will be displayed. The database locations where these values are stored for
CON0 are shown in brackets [ ].
Figure 7-12. Setpoint Parameter Configuration Window
ENTRY EXPLANATION
Tagname: Tagname of the CON module [A00].
Setpoint Mode: This parameter selects how the setpoint increase and
decrease pushbuttons function when the Controller is in
remote. Available selections [B338]:
No Effect
Remote SP Ratio - adjusts the Remote Setpoint Ratio
Remote SP Bias - adjusts the Remote Setpoint Bias
Remote Switch: This parameter is used in conjunction with the Remote
Setpoint Enable to choose between the remote and local
setpoint functions. Available selections [L113]:
Local
Remote
Remote Setpoint Enable: This parameter is used in conjunction with the Remote
Setpoint Switch to choose between the remote and local
setpoint functions. Available selections [L115]:
Disable
Enable