Micromod Micro-DCI: 53MT6000 Micro-Tools - Manual (Page 80)

53MT6000 INSTRUCTION MANUAL
64 Database Editor
7.4.8 PARAMETER Menu
There are eight PARAMETER modules available in the 53MC5000. Parameter modules are used to dis-
play or change specific database locations within the controller without having to access the engineering
mode of the controller. Typical values that can be configured include tuning parameters or alarm limits.
Names can be assigned to each of the point entries for added clarity.
Figure 7-17. Parameter Configuration Window
ENTRY EXPLANATION
Module ID: Selects the Module to be configured. Use the up or down arrow
buttons to cycle through the control module selection.
Tagname: Tagname (title) of this PARAMETER MODULE.
Point1 Name: Name of Point 1, the first point with its value displayed by the PAR
module; 10 characters maximum.
Point1 Designator: Database location of the first point whose value will be displayed.
Point2 Name: Name of Point 2, the second point with its value displayed by the
PAR module; 10 characters maximum.
Point2 Designator: Database location of the second point whose value will be
displayed.
Point3 Name: Name of Point 3, the third point with its value displayed by the PAR
module; 10 characters maximum.
Point3 Designator: Database location of the third point whose value will be displayed.
Modify Display Disable: This database parameter is used permit modification of Point 1-3
from the faceplate of the controller. Available selections:
Yes - permit changes
No - do not permit changes
OK: Saves changes, closes window and returns to main menu.
Save: Saves changes without closing window.
Cancel: Cancels changes and returns to main menu.