Multichannel Systems HiClamp Manual - Manual (Page 49)

Troubleshooting
43
6.2.1 Measuring the current amplitudes
Measurement of the peak ACh-evoked current is carried out automatically within boundaries
defined in the Set Cursor command. This command is activated by a single click on the button
presented in the right panel. Activation of the Set Cursor changes the display as follows.
Several cursor options are possible allowing measurements at the cyan and blue lines. Selection
“Cross Hair” returns the delta current between the two lines with the blue line at the minimum.
Min Max returns the delta current taking the minima and maxima between the two lines. –Min
returns the delta current between the value measured at the cyan position and the minimal value
measured up to the blue line. –Max returns the maximal delta current measuring the minimal
value at the cyan position and maximal between the two lines. –Min/First returns the minimal
value measured between the cyan (taken on the first measured curve) and blue line at the current
curve. Position of the minimal and maximal values determined for different curves can always be
visualized using the button. Positions will be represented on the data curves by a blue and red
circle.