Multichannel Systems HiClamp Manual - Manual (Page 50)

HiClamp Manual
44
Once cursors are set the ensemble of the data captured in a single run can be analyzed by
choosing the calculator mode and by a single click on the A/D after activation of the calculator
that is display in the right part of the commands.
Following the selection of the A/D the calculator should display the number 7, which corresponds
to the position of the A/D in the data acquisition program. Activation of the concentration
activation curve is performed by a click on the corresponding symbol (red curve). The successive
window allows the selection of the concentration of agonists that were tested in the experiment.
Following the selection of concentrations the graphs corresponding to the concentration
activation curves are automatically displayed.
In this graph the curves measured for each of the cell tested are represented as function of
the cell position in the loading plate. In this particular experiments five cells have been measured
during the sequence No. 3. Data can either be analyzed further within DataMining or saved for
later analysis with DataMerger. DataMerger is a companion program specially designed for the
analysis of results obtained in different experiments. A single click on the upper right icon saves
data for DataMerger. This will create a *.mat file that can later be open into DataMerger.