SecurityMan Air-AlArmII series - User manual - Manual (Page 10)

FOr MAnAGeMenT CenTer Use OnlY:
To upload arm/disarm to management center: PrGM + Password + enT + XX + enT_ _Enter 50 to disabled upload, enter 51 to
enable upload to management center, the default setting is 50 or disable. Leave this disable if management center is not in service.
User Code: PrGM + Password + enT + 80 + enT + XXXX + enT_ _ Enter a number between 0000~9999 for XXXX to setup
user code for management center. The default is set as random (For Ademco Management Center).
6
Operation
To record a voice message greeting: press and hold down the reC button located on the back side of the alarm host and
then speak close into the rear speaker of the alarm host. When finish recording, release the
reC button to save the recorded
message. The voice message greeting can be 10 seconds long.
To Playback the recorded voice message greeting: press and hold down the PlAY button located on the back side of the alarm host.
“One-key” Arm:
by remote controller: Press the AWAY (All Alarm) or the HOME (Part Alarm) button on the remote control to arm and the
alarm host will beep once to confirm the operation is successful. See Wireless Remote Controller on page 9 for more detail.
Arm by keyboard on alarm host: Press (All Alarm) or (Part Alarm) button, the alarm host will beep once to confirm
the operation is successful.
“One-key” Disarm:
by remote controller: Press the DISARM button on the remote control to disarm the alarm and the alarm host will beep twice
to confirm the operation is successful. Reference Wireless Remote Controller on page 9 for more detail.
Disarm by keyboard on alarm host: esC/DIsArM + Programming Password + enT_ _ Press the ESC/Disarm button follow by
the programming password and then ENT to disable alarm siren using the alarm host. The host will beep twice to confirm the
operation is successful.
emergency/Panic Distress:
by remote controller: Press the EMERGENCY
button on the remote control at times of emergency to immediately
activate the sound siren on the alarm host and wireless sirens.
by Keyboard on alarm host: Press the EMERGENCY button on the alarm host at times of emergency to immediately
activate the siren sound on the alarm host and wireless sirens.
Telephone alarm: After receiving the phone call from the alarm host, the recorded voice message will repeatedly play for 22
seconds. Before the 22 seconds are over, one of the following actions must be taken: