SecurityMan Air-AlArmII series - User manual - Manual (Page 8)

Three types of Defense line
Types of Defense Line and what they mean:
24-hour Defense line (Zone 1~5):
Sensors programmed into any of the 24-Hour defense zones are automatically set on a “24-Hour Monitoring Status”,
and usually consist of wireless panic buttons, smoke detectors & gas sensors (N/A).
1st Defense line (Zone 6~10):
Indicates the first defense areas or the perimeter zone (such as doors and windows). This is the perimeter areas
where thieves initiate when attempting to break in. These zones are generally composed of wireless smart door magnet
sensors and wireless curtain PIR sensors (N/A).
2nd Defense line (Zone 11~15):
Indicates the second defense areas, such as living room, aisles, bedrooms, hallways, etc. These zones are generally
composed of the wireless wide-angle PIR sensors where they can detect movements in open spaces.
How to change the programming password
The system default password is 888, to change the programming password press:
PrGM + 999 + enT + Three Digit new Programming Password + enT + Three Digit new Programming Password +
enT_ _
Press PRGM button, the programming LED light will come on, enter “999”, press ENT, then input a new three-digit
programming password, press ENT, re-input the new three-digit programming password, and then press ENT to complete
the programming password change. Notice the programming LED light will disappear after the final ENT is pressed.
Programming the Alarm Host (sM-8088T)
Function: Operation_ _Operation Explanation
• The alarm host will automatically exit from the programming status if inactive for 20 seconds.
• Programming is effective after PrGM+Password+enT command is pressed, use ESC button to go to previous step.
• The alarm host will beep in series to indicate the programming is successful and beep once to indicate programming failure.
IMPOrTAnT
PrGM + Password + enT_ This command applies throughout whenever programming the alarm host, before attempting to
change other programming features, such as Delay Time to Arm, Delay Time to Alarm, Emergency Alarm Voice, Adding and
Cancelling wireless devices, etc. For example; to change Delay Time to Arm below from the default 40 seconds to 1 minute,
4