SecurityMan Air-AlArmII series - User manual - Manual (Page 32)

28
Q9: Do I need to add each of the wireless devices that comes with the kit to the Alarm Host?
A9: No, each wireless device inside each Air-Alarm kits is already added by default.
Q10: How can I clear the enlisted telephone numbers from the list?
A10: To clear the enlisted telephone numbers press PRGM+password+ENT+01 (01~05 group no.)+ENT+ENT Or simply add
the enlisted telephone numbers to the same group to override the old.
Q11: My Alarm Host keeps on triggering during in coming and out going calls?
A11: Please disable the “Telephone Disconnection Alarm” by entering the following command
PRGM+password+ENT+60+ENT
Q12: How does sM-80 PIr Motion sensor work and why is it not sensitive enough?
Q12: SM-80 PIR Motion Sensor areas of detection is 110 degree, 30x30ft. It is immune to animals that are equal to or less
than 10kgs in weight, ie. dogs, cats, etc.
1) SM-80 can become less sensitive if the battery becomes weak; replace new 9VDC battery.
2) Try removing the sensor by following the “To Cancel” procedure in the user’s manual and then follow the “To Add”
and add it into another zone of the Alarm Host.
3) Power cycle both PIR motion sensor and Alarm Host.
Here is some examples of testing methods that is not recommended for SM-80 PIR Motion Sensor:
• Shaking one hand in the front of the PIR Motion Sensor. It might not sense well because the IR radiation from one hand
may be too small to detect.
• Moving an object (none temperature object), like a stick in the front of the PIR Motion Sensor. It may not sense
because sticks in general does not emit IR radiation.
• Moving out of the detection areas.