SecurityMan Air-AlArmII series - User manual - Manual (Page 20)

The PIR (SM-80) sensor featured Zone Alert which send the signal to the alarm host to beep in series notifying there is
someone in the front of the motion sensor in alarm Disarm mode. Each time the motion sensor detects movement the
alarm host will beep 5 times. By default the Zone Alert feature is set as disable. Here are some scenario characteristics
behavior of the PIR Zone Alert feature in Arm mode and in Disarm mode:
1) When Alarm Host Is In Disarm Mode:
A) If sensing PIR detects movements, the alarm host will beep 5 times each time the PIR detect movements.
B) Since PIR sensing device is designed to conserve battery life by active scanning for movements every 5 seconds,
the alarm host may not beep 5 times when PIR scanning is inactive.
2) When Alarm Host Is In Arm Mode:
A) If sensing PIR detects movements within 40 seconds of exiting delay time, the alarm host will charm 5 times to
indicates the alarm system is in the exiting delay time. The exiting delay time of 40 seconds is the default setting,
alternatively it can be change to 1 minute. Please note that the alarm system will NOT sound off if the sensing
device pickup movements within this time frame.
B) If sensing PIR detect movements after 40 seconds of exiting delay time, the alarm system will trigger the sirens and
sound off normally. The exiting delay time of 40 seconds is the default setting, alternatively it can be change to 1 minute.
Zone Alert On/OFF (sM-80 and sM-8088T alarm host)
Zone Alert ON:
Press PRGM + Password + ENT + 92 + ENT + XX + ENT [XX means input zone 11~15]
Zone Alert OFF (Default):
Press PRGM + Password + ENT + 93 + ENT + XX + ENT [XX means input zone 11~15]
**Zone Alert can be turn ON or OFF in any specific zones from 11 through 15.
**In alarm Disarm mode, when PIR sensor picked up motion, the alarm host will beep 5 times each time the PIR senses motion.
Adding and Canceling PIr Motion sensor:
To Add:
Step 1: Press PrGM + Password + enT + 70 + enT+ XX + enT The “ ” light will appear solid blue.
[The XX indicate zone number of the 2nd defense line, including zones 11 through 15].
Step 2: Press the “Learning Emitting Switch” twice consecutively to trigger PIR sensor, the alarm host will beep
in series, and the “ ” light flash 5 times and then turn off to indicate the PIR motion sensor has been
successfully added.
To Cancel:
Press
PrGM+ Password + enT + 71 + enT+ XX + enT The alarm host will beep twice then the “ ” light
flash once and then turn off to indicate the PIR motion sensor has been successfully cancelled.
[The XX indicate zone number of the 2nd defense line including zones 11 through 15]
16