SecurityMan Air-AlArmII series - User manual - Manual (Page 19)

* Please use screw (e) to install the bracket (see page26)
Wireless Wide-Angle PIR Motion Sensor (SM-80)
Functions/Features:
• Mainly monitor and control indoor stereoscopic spaces, generally set as a 2nd Defense Line.
• When human body enters the detection areas, the motion sensor will transmit the alarm signal to the alarm host.
• It is immune to pets; cats, dogs, etc that are less than 10KGS will not cause false alarm.
specifications:
• Operating power: 9V Battery (Recommend: alkaline battery)
• Wireless Transmitting distance: ≥450ft (in open area)
• Service life: ≤2 years
• Detection Area: 110° 10 x10m
Installation and Usage:
Mount the bracket to a desired wall surface, location, or corner at a height of about 6ft to 7ft above the ground.
Open the sensor cover and connect a 9VDC battery. Next, refers to the diagrams above to adjust and select the Jumper
Line timer between 5S or 5MIN for the motion sensor to detect once every 5 seconds or the sensor to detect once every
5 minutes. Recommended to use “5S” default “setting for normal use. Skip “To Add” motion sensor below for newly
added motion sensor before closing the sensor cover and proceed to the next step. Match the grooves of the sensor to
the bracket and slide the motion sensor down from top to bottom to secure. Adjust the sensor to a proper angle and then
slide the power switch located on the side to the “ON” position. The motion sensor takes 30 seconds to become active
for operation (normal working state) after switching “ON”. A red light will flash for motion detection, a frequent green
light flashing means it is time to replace the battery.
15