SecurityMan Air-AlArmII series - User manual - Manual (Page 17)

13
Adding and Cancelling smart Door/Window sensor:
To Add:
Step 1: Press
PrGM + Password + enT + 70 + enT+ XX + enT The “ ” light will appear solid blue.
[The XX indicate zone number of the 1st defense line, including zones 06 through 10 ].
Step 2: Triggers the Smart Door/Window magnet twice consecutively, the alarm host will beep in series and the
“ ” light flashes five times and then turns off to indicate the magent Smart door/ window sensor has been
success fully added.
To Cancel:
Press
PrGM + Password + enT + 71 + enT+ XX + enT The alarm host will beep twice then the “ ” light
will flash once and then turn off to indicate the magnet Smart door/ window sensor has been successfully cancelled.
[The XX indicate zone number of the 1st defense line including zones 06 through 10].
note: The alarm host can only learn 1 wireless device (Magnet smart Door/Window sensor) at a time, a total of 4
wireless devices (magnetic sensors) to a zone can be added. For example; for the 1st defense line, if 4 sensors were
to be added to zone 06 through zone 10, there would be a total of 20 sensors in all. If 1 device is removed from a
zone that contain 4 devices, then all 4 devices in the zone will be removed, and each device will have to be added
again by following the “To Add” proceedures above.
Wireless Doorbell Button (SM-82)
Doorbell button back Mounting bracket
* please use screws (F) to install the mounting bracket. (see page 26)
Functions/Features:
• Installed on an entrance door.
• The alarm host will make 3 “Ding Dong” sound per ring.