SecurityMan Air-AlArmII series - User manual - Manual (Page 18)

• Low-battery LED indication
specifications:
• Operating power: Li-ion battery (3.7V / 200mA)
• Charging time: 12 hours
• Emitting distance: ≥150m (in open area)
• Service life: ≤3 year
Installation and Usage:
Install the mounting bracket using the screws provided to a desire location intended for visitors to ring the doorbell.
Situate it about 1.4m above the ground is recommended. Next, switch the power switch to the ON position on the
doorbell and then place it in an up right position over the mounting bracket and slide the doorbell down to secure the
doorbell. Press on the doorbell button once to get three doorbell sound on the alarm host and the blue LED light status
will appear on the doorbell to indicate that the host is ringing. Recharge the battery when the low-battery LED light
flashes blue by connecting the doorbell to a computer USB port with the USB cable provided or any third part USB A/C
adapter (5VDC, 500mA).
Adding and Cancelling Doorbell button:
To Add:
Step 1: Press PrGM + Password + enT + 70 + enT + XX + enT The “ ” light will appear solid blue.
[The XX indicate zone number of the defense line, including zones 06 through 15].
Step 2: Press the doorbell button twice consecutively, the host alarm will beep in series and the “ ” light flash
5 times and then turn off to indicate the doorbell button has been successfully added.
To Cancel:
Press PrGM + Password + enT + 71 + enT + XX + enT The alarm host will beep twice then the “ ” light
will flash once and then turn off to indicate the doorbell button has been successfully cancelled.
[The XX indicate zone number of the defense line including zones 06 through 15].
note: 1. The alarm host can only learn 1 wireless device (Wireless Doorbell button) at one time, a total of 4
wireless Devices (Wireless Doorbell buttons) to a zone can be added.
2. The programming code of Wireless Doorbell button is special which do nOT occupied as one of the additional
sensor added to that zone, therefore 4 devices can still be added plus the wireless doorbell button.
3. If 1 Wireless Doorbell button is removed from a zone, then all wireless devices (Wireless Doorbell
button and wireless sensors) in the zone will be removed, and each device will have to be added again by
following the “To Add:” procedures above.
14