SecurityMan Air-AlArmII series - User manual - Manual (Page 21)

17
note: The alarm host can only learn 1 wireless device (Magnet smart Door/Window sensor) at a time, a total of 4
wireless devices (magnetic sensors) to a zone can be added. For example; for the 1st defense line, if 4 sensors were
to be added to zone 06 through zone 10, there would be a total of 20 sensors in all. If 1 device is removed from a
zone that contain 4 devices, then all 4 devices in the zone will be removed, and each device will have to be added
again by following the “To Add” procedures above.
Wireless Indoor Siren (SM-103W)
Functions/ Features:
• Wireless receiving indoor alarm siren, spot alarm sound and flashes
• Plugs into wall outlets, for indoor use only.
specifications:
• Operating Power: 100—240VAC
• Wireless Receiving distance:≥210 ft (In open area)
• Siren Sound 105dB
Installation and Usage:
Plug the wireless indoor siren into an electrical power outlet and wait 30 seconds. By default the indoor siren is already
paired with the alarm host unit. Recommended to install 4~5ft high from the ground. If the siren does not perform normal
or do not siren, please reference the “To Add:” procedures below to program the siren to the alarm host.
After installation and setup, the siren will sound when the alarm host is triggered by the inputting sensor(s). To disable
the siren sound please disarm the alarm host unit with a remote control by pressing on the unlock icon or use ESC +
Password + ENT by keypad. If the alarm host is not disarm, the siren will sound off for 3 minutes and then automatically
turns off after 3 minutes of alarming.