IDEC FS1A Controller - Manual (Page 37)

4-4
3. Confirm the configuration and press the
enter button.
Confirm that the selected logic switch matches
the blinking logic LED, and then press the enter
button by using configuration tool.
Be sure to confirm that they match. If the switch
configuration and display do not match and you
press the enter button, unintended logic may be
activated.
Press and hold the enter button for 1 to 5s to
enable the configuration. "C" blinks in the error
LED display while you press the enter button. If
you press the enter button for less than 1s or
more than 5s, the logic is not activated.
4. Confirm that the logic is activated.
The logic LED display changes from a blinking
display to solid display, the error LED turns off,
and the selected logic is activated.
After configuring the logic, be sure to confirm that
the selected logic is activated.
5. Lock the protective cover.
Close and lock the protective cover.
Refer to "Using the protective cover" in this
chapter for details. To protect the configuration
setting, it is recommended that the protective
cover be locked.
LOGIC No. TIMER (S)
ENTER
0 .1 .5 1 2 5 15 30 1 2 3 4 5 6 7 8
0 .1 .5 1 2 5 15 30
SAFE-IN TIMER(S)
SAFE-OUT
SOLENOID
-OUT
START-IN
X0 X1
X2 X3
X4 X5
X6 X7
X10 X11
X12 X13
X14 X15
X16 X17
Y0 Y1
Y2 Y3
Y17 Y20
LOGIC ERROR
LOGIC No. TIMER (S)
ENTER
0 .1 .5 1 2 5 15 30 1 2 3 4 5 6 7 8
0 .1 .5 1 2 5 15 30
SAFE-IN TIMER(S)
SAFE-OUT
SOLENOID
-OUT
START-IN
X0 X1
X2 X3
X4 X5
X6 X7
X10 X11
X12 X13
X14 X15
X16 X17
Y0 Y1
Y2 Y3
Y17 Y20
LOGIC ERROR
LOGIC No. TIMER (S)
ENTER
0 .1 .5 1 2 5 15 30 1 2 3 4 5 6 7 8
0 .1 .5 1 2 5 15 30
SAFE-IN TIMER(S)
SAFE-OUT
SOLENOID
-OUT
START-IN
X0 X1
X2 X3
X4 X5
X6 X7
X10 X11
X12 X13
X14 X15
X16 X17
Y0 Y1
Y2 Y3
Y17 Y20
LOGIC ERROR
(Blinking)
Fig. 4.4 Confirmation of logic switch
configuration and LED indication
(Configuration state)
Fig. 4.5 LED indication during enter
button is valid (Configuration state)
Fig. 4.6 Completion the configuration
of Logic “7 “(Run state)