Staub Electronics WPS-100-DVR-8CH WIREPATH - 8 CHANNEL DVR W_500GB HDD User Manual
Page 32
32
WPS-100-DVR-8CH Installation and Users Manual
6.2.1 VIDEO LOSS SETUP
Video Loss Setup allows the administrator to define how the system responds when video signal is lost for
the camera.
In the Camera Setup menu, highlight Settings in Video Loss and press the ENTER button on the front panel
of the DVR or remote control to display Video Loss Setup sub menu for the selected camera.
To navigate and operate this menu:
• ▲▼◄►
Press these buttons on the front panel of the DVR or remote control to select an item.
Alternatively use the mouse to select an item.
• NUMERIC
Press these buttons on the front panel of the DVR or remote control to change the camera. Alternatively
use the mouse to select the desired camera.
•
COPY
( )
Press
the
COPY button on the front panel of the DVR or remote control to copy the Video Loss settings
of the focus camera to all of the cameras.
• ESC
Press
the
ESC button on the front panel of the DVR or remote control to escape from this menu and
return to the main menu. Alternatively use the mouse to exit the sub menu by clicking on the “X.”
If the contents in this menu have been modified, a Save dialog box will be displayed requesting the
user to save the changes. Press ENTER on the front panel of the DVR or remote control to exit and save,
ESC to exit without saving. Another method to escape is to use the mouse to “right-click” and exit the
sub menu.
The following is a brief description for each item in the sub menu and its specific operations:
• DURATION
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once video
loss is detected for this camera. The buzzer and Alarm Out relay will reset immediately once video signal
is restored. Press +/- buttons to adjust the value from 3 seconds to 60 minutes or ‘-‘ for indefinite, requiring
the Alarm Reset button to be pressed.
• CAMERA TO GO
The
Camera To Go setting will specify which PTZ camera will go to a predefined preset when video loss
is detected for this camera. This feature can only be used with a PTZ camera.