Staub Electronics WPS-100-DVR-8CH WIREPATH - 8 CHANNEL DVR W_500GB HDD - Manual (Page 68)

68
WPS-100-DVR-8CH Installation and Users Manual
2. Press Play (►/II, ► ►) button on the front panel of the DVR or on the remote control to playback all
the selected events. Alternatively use the mouse to select the Play button.
3. Press Copy ( ) button on the front panel of the DVR or on the remote control to backup (copy)
all of the selected recorded video and audio events to the connected backup device.
Alternatively use the mouse to select the Copy button. The Backup menu (described in
the Archive portion of Section 8.6) will be displayed.
• AREA
Area defined as the motion area for the video to be searched for matching files. Use the buttons on the
front panel of the DVR or the remote control to highlight Area and press ENTER to display Motion Area
Setting screen as shown below.
In the Motion Area Setting screen use the white mask window to define the Smart Search area in the
same manner as setting up Motion Detection (see Section 6.2.2).
Note: The area of a video searched using Smart Search must be part of the defined area for Motion
Detection (see Section 6.2.2). Only files with motion covering all of the defined motion area will be
displayed as matching results. Therefore, based on the search algorithm, there will be more matching
files for smaller defined motion areas.
The following is a brief description for each item in this menu and its specific operations:
• ▲▼◄►
Press these buttons on the front panel of the DVR or remote control to move the Mask window
(grids white in color). Alternatively use the mouse to select and move the Mask window (grids
white in color) by “left clicking” and dragging the mouse over the desired area.
• +/-
Press these buttons on the front panel of the DVR or remote control to resize the Mask window
(grids white in color). Alternatively use the mouse to select and move the Mask window (grids
white in color) by “left clicking” and dragging the mouse over the desired area.
• ENTER
Press this button on the front panel of the DVR or remote control to Set/Reset the area of the Mask
window (grids white in color). Alternatively use the mouse to select the Mask icon and adjust the
Mask window (grids white in color). Once the mask area is set, the mask window will change to yellow.