Staub Electronics WPS-100-DVR-8CH WIREPATH - 8 CHANNEL DVR W_500GB HDD User Manual
Page 91
91
WPS-100-DVR-8CH Installation and Users Manual
© 2012 Wirepath Surveillance
The following is a brief description for each item in this menu and its specific operations:
• CAMERA
Select the camera to define motion triggered events.
• DURATION
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once
motion is detected for this camera. The buzzer and Alarm Out relay will reset immediately once motion
is no longer detected.
• CAMERA TO GO
The Camera to Go setting will specify which PTZ camera will go to a predefined preset when motion is
detected for this camera. This feature is used in a system that includes PTZ cameras since the Camera
to Go must be a PTZ camera.
• GOTO PRESET
This feature works in conjunction with the Camera to go setting above and defines the preset position the
Camera to Go PTZ camera will go to when motion is detected for this camera. For more details about
preset positions for PTZ cameras, please refer to Section 7.
• PRE-RECORD
Define how much time the DVR will record before motion is detected. The Pre Record FPS set in Section
9.3.5 determines the frame rate of this recording.
Note: Actual pre-record time may be shorter than the value set if the total size of the pre-record video
exceeds the pre-record video buffer.
• POST-RECORD
Define how much time the DVR will record after motion is detected. The Post Record FPS set in Section
9.3.5 determines the frame rate of this recording.
• ALARM OUT
Define which Alarm Output will be triggered when motion for this camera is detected. Select N/A for
none or either of the Alarm Outputs (1 for NC or 2 for NO).
• BUZZER
By default the internal buzzer is disabled to sound when motion for this camera is detected.
• LOG
By default, the DVR will log to the Event Log when motion is detected.
Send an email message to predefined email address in the event motion detected for this camera.
See Section 9.3.11 for more information on e-mail.
• FTP
This DVR can send the recorded motion detection event for this camera to an FTP server.
• SCREEN MESSAGE
By default, the DVR will display a motion detection message in the System Status Bar (visible from the VGA
or BNC main monitor output only) when motion is detected for this camera.