Staub Electronics WPS-100-DVR-8CH WIREPATH - 8 CHANNEL DVR W_500GB HDD - Manual (Page 93)

93
WPS-100-DVR-8CH Installation and Users Manual
© 2012 Wirepath Surveillance
• LOG
By default, the DVR will log when video loss is detected to the Event Log.
• E-MAIL
This DVR can send an email message to a predefined email address in the event video loss is detected for
this camera. The default setting is disabled. See Section Section 9.3.11 for more information on e-mail.
• FTP
This DVR can send the recorded video loss event for this camera to a FTP server. The default setting
is disabled.
• SCREEN MESSAGE
By default, the DVR will display a video loss message in the System Status Bar (visible from the VGA
or BNC main monitor output only) when video loss is detected for this camera.
9.3.8 ALARM
The Alarm Setup allows the administrator to define the attributes for each alarm input and the actions if it
is triggered. Up to four alarm inputs such as motion detectors or door contacts that can be connected
to the DVR.
The following is a brief description for each item in this menu and its specific operations:
• NORMAL STATE
Select N/A, Close or Open. The type of sensor connected to the DVR will determine the setting.
For example, motion detectors typically are normally open while door contacts are normally closed.
Select N/A (Not Available) if the input is not used and the following items will not be adjustable. The
default setting is Open.
• FOCUS CAMERA
The camera associated with the alarm input.
• DURATION
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once
the alarm input is triggered. The buzzer and Alarm Out relay will reset immediately once motion is no
longer detected. If ‘-‘ for indefinite is selected, the Alarm Reset button on the remote control will have
to be pushed to reset the alarm.