Staub Electronics WPS-100-DVR-8CH WIREPATH - 8 CHANNEL DVR W_500GB HDD - Manual (Page 87)

87
WPS-100-DVR-8CH Installation and Users Manual
© 2012 Wirepath Surveillance
• DDNS Username
Enter the DDNS username if DDNS is used. – Not used unless an existing DDNS other than WirepathDNS service is
configured.
• DDNS Password
Enter the DDNS password if DDNS is used. – Not used unless an existing DDNS other than WirepathDNS service is
configured.
• WAP Picture Quality
WAP (Wireless Application Protocol) is a simple standard for remote devices (such as Smartphones) to
access the DVR. See Section 9.6 for more information on WAP.
• Video Stream
Video Stream (Dual Streaming) allows the user to choose the resolution and speed the video is delivered to
the remote device (see Section 9.4). This is especially helpful for remote devices on slower networks. Reducing
resolution sent to these devices will speed up the delivery of the video. To enable Dual Streaming, select one of
the four levels of QCIF (Fair is the lowest quality while Superfine is the highest quality). If Dual Streaming is used,
the total system recording rate will be reduced. The default value is Record, which means that Dual Streaming is
not enabled and the output of the DVR to remote devices will match the Best Rec Resolution set in Pre Camera
(See Section 9.3.4).
Note: To use Dual Streaming in Internet Explorer, the user must select Extra Video Stream option in the Modify
menu of the Device List of the remote PC (See Section 9.4).
- QCIF Fair – Lowest QCIF Resolution -
- QCIF Normal – Medium QCIF Resolution
- QCIF Fine – High QCIF Resolution
- QCIF Super Fine – Best QCIF Resolution