Staub Electronics WPS-100-DVR-8CH WIREPATH - 8 CHANNEL DVR W_500GB HDD - Manual (Page 94)

94
WPS-100-DVR-8CH Installation and Users Manual
• GOTO PRESET
Define the preset PTZ position the Focus Camera will go to if the alarm input is triggered (the focus
camera must be a PTZ camera for this feature). For more details about preset positions for PTZ
cameras, refer to Section 7.
• PRE-RECORD
Define how much time the DVR will record before the alarm input is triggered. The Pre Record FPS set
in Section 9.3.5 determines the frame rate of this recording
Note: Actual pre-record time may be shorter than the value set if the total size of the pre-record video
exceeds the pre-record video buffer.
• POST-RECORD
Define how much time the DVR will record after the alarm input is triggered. The Post Record FPS set in
Section 9.3.5 determines the frame rate of this recording.
• ALARM OUT
Define which Alarm Output will be triggered when the alarm input is triggered.
• BUZZER
By default, the internal buzzer is enabled to sound when the alarm input is triggered.
• LOG
By default, the DVR will log when the alarm input is triggered to the event Log.
• SCREEN MESSAGE
By default, the DVR will display a message in the System Status Bar (visible from the VGA or BNC main
monitor output) when the alarm input is triggered.
• E-MAIL
Send an email message to a predefined email address in the event the alarm input is triggered. The
default setting is disabled. See Section 9.3.11 for more information on e-mail.
• FTP
This DVR can send the recorded video from the associated camera when an alarm input is triggered.