ZOLL AED Pro Rev J - Manual (Page 76)

C HAPTER 6 N ONRESCUE M ODE
6–4 www.zoll.com 9650-0350-01 Rev. J
Communicating with an External Device
For many nonrescue operations (such as data transfer or device configuration), the AED Pro
unit must establish a connection with an external device.
Setting Up Data Communications with an IrDA Connection
You can transfer data from an AED Pro unit to an external device through an IrDA (infrared
wireless) connection. The AED Pro unit has an IrDA port on its right side, near the Ready
indicator. The external device (such as a personal computer or personal digital assistant) must
have an IrDA port as well. For IrDA adapters, refer to “Accessories” on page 1-6.
For best transmission results, the IrDA ports must be facing each other, with a clear 10- to
18-inch line-of-sight between devices.
Start the ZOLL Administration Software or RescueNet Code Review software on the computer.
Press and hold the On/Off button on the AED Pro unit for at least 5 seconds to enter nonrescue
mode (see page 6-2). The AED Pro unit establishes contact with the computer within 5 seconds
and issues the voice and text message COMMUNICATIONS ESTABLISHED; otherwise, it
shuts down.
Downloading Data to a USB Device
You can also download patient data to a portable USB device for use with RescueNet Code
Review software.
Press and hold the On/Off button on the AED Pro unit for at least 5 seconds to enter nonrescue
mode (see page 6-2). Attach a USB device to the port inside the battery compartment, then
press the USB softkey. The unit issues the voice and text message USB DEVICE
CONNECTED.
Press the New softkey to download all new patient data since the last download. Press the All
softkey to download all patient data on the unit. The unit issues the voice and text message
DOWNLOADING DATA.
If there is no USB device attached, or if the unit fails to establish a connection with the USB
device, the unit issues the command INSERT USB DEVICE.
VERSIONS
00:00:38
B:01.51 L:01.67 P:02.61
H:02.00 C:02.00
NEW ALL