ZOLL Propaq MD Rev B - Manual (Page 62)

58 9650-0801-01 Rev B
Removing the Printer Module
Tools Required
• #1 Phillips screwdriver with torque capability
• Orange (wooden) stick
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
To reinstall the printer module, reverse the steps.
Printer Disassembly
1 Place the unit screen down on the mat in a
horizontal position.
2 Open the printer housing and remove the
printer paper.
3 Remove the two (2) screws inside the
printer module in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
4 Remove the two (2) screws on the outside
of the printer.
Note: During reassembly, torque screws to
6 in-lbs.
5 Slowly remove the printer from the unit,
being careful not to strain the cables.