Progressive International Electronics C2000 - Manual (Page 19)

C2000 Operation
‚ 13
the Select Function menu. Press <SELECT> again to read the
console clock.
A special select function is required to turn off the C2000. By
pressing <PUMP STOP> at the Select Function prompt, the
console is placed in an off mode. At this point, all LEDs are
turned off and the work Off flashes on the display. Note that any
fueling transactions that have already begun when the C2000 was
turned off will be allowed to run to completion. To turn the C2000
back on, press <CLEAR>; then enter the Operator PIN Code on
the numeric pad and press the <ENTER> key. The default
Operator PIN Code is set at the factory to 1111. Operator PIN
Codes do not appear in the display as they are entered on the
numeric keypad. (See the Program & Report Section of this
manual for instructions on changing the Operator PIN Code.)