Progressive International Electronics C2000 - Manual (Page 49)

C2000 Installation
‚ 43
Wayne/Dresser Electronic Fuel Pumps
Read entire installation section before attempting to install
system. Take careful note of warnings in this section before
mounting C2000.
Mount the C2000's configurator box on the wall or under the
counter so that no cables are strained.
1. Install the Wayne/Dresser pumps according to the
Wayne/Dresser installation instructions. Connect the pump
data wires to the model DD/DY2400/16 connection box
according to the Wayne/Dresser installation instructions.
2. Locate the C2000's pump connection cable. Connect the
wires into the Wayne/Dresser connection box, as shown in
Figure 13.
Figure 13: Wayne/Dresser Distribution Box