Progressive International Electronics C2000 - Manual (Page 24)

C2000 Program & Report
‚ 18
To set the service mode, press the <CHANGE> key to toggle
between full- or self-service for the specified pump.
If the dispenser is a blending dispenser, on the numeric keypad
enter the amount, in percent of hose 1, to be dispensed by the
selected hose. Press <ENTER>. Remember that any data
entered on the numeric keypad will appear on the display. If
the dispenser is a multi-product dispenser, then press
<SELECT> to scroll to the next hose to be programmed.
Follow this procedure to program each pump/dispenser at the
site.
To exit Mode 1, press the <MANAGER> key. The C2000
display returns to the mode entry prompt. To exit programming
mode completely, press the <MANAGER> key again. The
C2000 will return to operator mode.
Mode 2 — Product Information (Manager only)
In this mode, Product Name, Cash PPU and Credit PPU for
each product at the site are programmed. To enter this mode
from the mode number prompt, press <2> on the numeric
keypad and then press <ENTER>. You are now in Mode 2.
The display now prompts for information about product #1. To
assign a product name such as UL, REG or DIESEL to this
product, press the <GRADE> key until the desired product
name is presented in the display. If you wish to just view the
product name already assigned, press the <SELECT> key and