Progressive International Electronics C2000 - Manual (Page 34)

C2000 Program & Report
‚ 28
Select the report number and enter it on the C2000 keypad; then
press <ENTER>. Data for the report will be printed. If you
wish to print additional reports, select another report option. Or
press <MANAGER> to exit Mode 11.
Mode 12 — Clear Resettable Totals (Manager/Operator)
Mode 12 is used to reset resettable totals by clearing them to
zero. Enter <12> and press <ENTER> to enter Mode 12.
The display will show press clear. If you wish to zero all
resettable totals, proceed by pressing <CLEAR>.
Press any key to exit Mode 12.
Mode 97 — Program Operator PIN Code
(Manager only)
WARNING: Care should be observed when using this mode.
If the PIN Code is altered, be sure to make note of the new PIN
Code and save in a safe location.
In Mode 97, the Operator PIN Code is viewed and changed.
(The default Operator PIN Code is 1111.) To enter this mode,
enter <97> on the numeric keypad and press <ENTER>. The
display will show the existing Operator PIN Code. To change
the code, enter the new number (up to 4 digits) on the numeric
keypad and press <ENTER>. The new Operator PIN code will
appear on the display. To exit this mode, press the
<MANAGER> key.