Progressive International Electronics C2000 - Manual (Page 42)

C2000 Installation
‚ 36
Tokheim Electronic Fuel Pumps
Read entire installation section before attempting to install
system. Take careful note of warnings in this section before
mounting C2000.
Mount the C2000's configurator box on the wall or under the
counter so that no cables are strained.
For Pumps Using Tokheim M98 Computer/Power Center:
1.
Install the Model 98 Computer/Power Center box and
Tokheim pumps according to Tokheim installation
instructions. Pumps must work in stand-alone before
proceeding. Pumps should be configured in the same
manner as for the Tokheim Model 179 Console.
Figure 7: Tokheim 98 Installation
2. Locate the C2000 pump connection cable. This cable has a
DE9S connector with hood on one end and a round
connector on the other end.