Progressive International Electronics C2000 - Manual (Page 28)

C2000 Program & Report
‚ 22
the display.
Press <ENTER> to advance the menu. The display will now
prompt an entry for correct data bit selection. Press the
<SELECT> key until the desired data bit selection appears in
the display.
Again, press <ENTER> to advance the menu. Here, the
display prompts an entry for correct stop bit selection. Press
the <SELECT> key until the desired stop bit selection appears
in the display.
Press <ENTER> again to advance the menu. The display will
prompt an entry for correct parity selection. Press the
<SELECT> key until the desired parity selection appears in
the display. If parity is enabled, press <ENTER> to advance to
parity type menu. At this point the display will show odd
parity. To toggle to even parity, press <SELECT> key.
To review your selections for the serial port, simply press
<ENTER> and scroll through all of the port parameters.
Mode 5 may be exited by pressing the <MANAGER> key.
The C2000 will return to the mode entry prompt on the display.
To exit programming mode completely and return to operator
mode, press the <MANAGER> key.