Progressive International Electronics C2000 - Manual (Page 37)

C2000 Installation
‚ 31
General Installation Guidelines
The basic C2000 system consists of several components — the
console, configurator box and cables to interconnect the
components. Refer to Figure 1, which shows a typical layout of
the C2000 system, including attachment to an optional printer.
To begin installation, place the console at the checkout counter of
the station. Note that the console has four threaded inserts on the
bottom for mounting with screws to a cellular telephone stand (not
provided). This will allow the console to be elevated and angled
for efficient use next to the cash register.
Next, locate the configurator box and mount under the counter or
on a wall adjacent to the console, not more than five feet away.
Attach the console/configurator cable to the 15-pin connector on
the back of the C2000. Plug the other end into the input connector
(9-pin) on the configurator box. If a printer is to be used with the
C2000, attach the printer cable to the 25-pin connector on the back
of the printer and the other end to the 9-pin serial port connector
on the back of the console.
Attach the C2000 system to the dispenser data distribution
equipment for the appropriate pump type, as outlined in the
following pages.
Upon completion, apply power to the C2000 console and
configurator box, as well as the printer (if applicable) and
commence programming, as outlined in Program & Report.