Progressive International Electronics C2000 - Manual (Page 26)

C2000 Program & Report
‚ 20
Mode 3 — Beeper Settings (Manager only)
Mode 3 is used to program single or continuous beeps for
Handle, Collect and Drive-Away. (Note: The console defaults
to a single beep unless set otherwise.) To enter Mode 3 from
the mode number prompt, enter <3> on the numeric keypad and
press <ENTER>.
The display first will prompt for selection of the style of beep
associated with a Handle/Call for Service. To change the style
of beep, press the <SELECT> key and toggle between single
and continuous.
To proceed to the next option setting, press <ENTER>. The
display now prompts for selection of the style of beep
associated with a Collect condition. To change the style of
beep, press the <SELECT> key and toggle between single and
continuous.
To proceed to the next option setting, press the <ENTER> key.
The display now prompts for selection of the style of beep
associated with a Drive-Away condition. To change the style
of beep, press the <SELECT> key and toggle between single
and continuous.
Exit Mode 3 by pressing the <MANAGER> key. The mode
entry prompt will appear on the display. To exit programming
mode completely and return to operator mode, press the
<MANAGER> key again.