Progressive International Electronics C2000 - Manual (Page 45)

C2000 Installation
‚ 39
Kraus Micon 100 Electronic Fuel Pumps
Read entire installation section before attempting to install
system. Take careful note of warnings in this section before
mounting C2000.
Mount the C2000's configurator box on the wall or under the
counter so that no cables are strained.
1. Connect the data wires (TTC, TTP, DCC) into the pump
connectors on the configurator box for the Kraus system.
Refer to Figures 9, 10, and 11, as well as Table 6.
Figure 9: Configurator Box for Kraus 16-Hose Systems