Progressive International Electronics C2000 - Manual (Page 27)

C2000 Program & Report
‚ 21
Mode 4 — Clock/Calendar (Manager only)
Mode 4 allows the setting of time and date. To enter mode 4,
press <4> and press <ENTER>. The C2000 is now in
programming Mode 4.
Time and date already set in the C2000 will be displayed. To
change the time, enter the new time on the numeric keypad in
24 hour format. The new time will appear in the display as you
enter it. Press <ENTER> and the time will be updated in the
C2000.
Next, you may change the date by entering the new date on the
numeric keypad in mmddyy format. The new date will appear
in the display as you enter it. Press <ENTER> and the date
will be updated in the C2000.
To exit Mode 4, press the <MANAGER> key. The mode entry
prompt will appear on the display. To exit programming mode
completely and return to operator mode, press the
<MANAGER> key again.
Mode 5 — Serial Port (Manager only)
Mode 5 allows configuration of the C2000 serial port. To enter
Mode 5, press <5> and press <ENTER>. The C2000 is now in
programming Mode 5.
The display now prompts a selection for the correct baud rate.
Press the <SELECT> key until the desired baud rate appears in