Progressive International Electronics C2000 - Manual (Page 44)

C2000 Installation
‚ 38
For Pumps Using Tokheim Model 67 Connection Box:
1.
Install pumps and connect wires to the Tokheim 67
connection box according to Tokheim instructions.
Configure pumps as for Tokheim MIMS IV.
Figure 8: Tokheim 67 Installation
2. Locate the C2000's pump connection cable. This cable has
a DE9S connector with hood on one end and a round
connector on the other end.
3. Connect the C2000's pump connection to the connector on
the Tohkeim configurator box. Be sure to screwlock this
connector to the Tokheim configurator box with the
screws provided.
4. Locate the other end of the C2000's pump connection
cable. Connect the round connector to the cable from the
Tokheim 67 into the connect box. Ensure that this cable
connection is screwlocked together. The connection must
not be subjected to harsh environments such as under
water, extreme heat or extreme cold, etc.
5. Connect the wall transformer into a 115 VAC receptacle.