Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 28)

Chapter 2 Part Names and Functions
2-5
F: USB Host Interface (USB)
USB 1.1 compliant.
One port for TYPE-A connector.
Power supply voltage: DC5V ±5%.
Maximum output current: 500mA
Maximum communication distance: 5m
Interfaces to transfer cable, USB-compatible
printer, and other compatible devices.
G: CF Card Cover
The CF Card I/F and DIP Switches are located in
the CF Card Cover opening. This cover must be
closed when accessing the CF Card.
H: DIP Switches
* When the unit turns ON with DIP switch 2 ON, the unit starts in transfer mode. Under normal operating
conditions, set to OFF.
DIP
Switches
Function ON OFF Note
1 Start up from CF Card Enabled Disabled
CF Card with startup
data required
2* Forced transfer mode
Forced Transfer
Mode: ON Forced Transfer
Mode: OFF
-
3 Reserved - - Constantly OFF
4
Simulate cover closed,
allowing card to be read
even if cover open
Enabled Disabled
Used when CF Card
cover is damaged
F
G
H
Bottom
(With CF Card Cover open)
1 2 3 4
ON