1 st-3200 series, 1 general specifications, 1 st-3200 series -2 – Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 33: 1 general specifications -2, St-3200 series
ST3000 Series Hardware Manual
3-2
3.1
ST-3200 Series
3.1.1
General Specifications
Electrical Specifications
Environmental Specifications
Power Supply
Input Voltage
DC24V
Rated Voltage
DC19.2 to 28.8V
Allowable Voltage Drop
2ms (max.)
Power Consumption
13W (max.)
In-Rush Current
60A (max.)
*1
*1.
The FWHM (Full-width, half maximum) value is approximately 40µs. (When exceeding
30A)
Voltage Endurance
AC1000V 20mA for 1 minute
(between charging and FG terminals)
Insulation Resistance
DC500V 10M
Ω (min.)
(between charging and FG terminals)
Phys
ical
Surrounding Air
Temperature
0 to +50°C
*1
*1.
Extended use in environments where surrounding air temperature is 40°C or higher may
degrade the display quality and result in decreased contrast.
Storage Temperature
-20 to +60°C
Ambient Humidity
10 to 90% RH
(Wet bulb temperature: 39°C max. - no condensation.)
Storage Humidity
10 to 90% RH
(Wet bulb temperature: 39°C max. - no condensation.)
Dust
0.1mg/m
3
and below (non-conductive levels)
Pollution Degree
For use in Pollution Degree 2 environment.
Atmosphere
Free of corrosive gases
Air Pressure Vibration
Resistance (altitude
range)
800 to 1114hPa
(sea level to 2000 meters above)
M
e
ch
ani
ca
l
Vibration Resistance
IEC61131-2 compliant
5 to 9Hz single-amplitude 3.5mm[0.14in]
9 to 150Hz constant-accelerated velocity 9.8m/s
2
X,Y,Z directions for 10 cycle (100 minute)
Concussion Resistance
IEC61131-2 compliant
(147m/s
2
X,Y,Z directions for 3 times)
Electrical
Noise Immunity
Noise Voltage: 1000V
P-P
Pulse Duration: 1
µs
Rise Time: 1ns
(via noise simulator)
Electrostatic Discharge
Immunity
6kV (complies with EN 61000-4-2 Level 3)