Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 89)

ST3000 Series Hardware Manual
4-10
‹ Wiring
When connecting the Power Cord, use the following items when performing wiring. (Items are made by
Phoenix Contact.)
‹ Connecting the Power Cord
When using the ST-3200/3300/3400 Series
(1) Confirm that the power cord is unplugged from the power supply.
(2) Remove the power connector (plug) from the main unit when using the ST-3200/3300 Series.
(When using ST-3400 Series, the power connector (plug) is packaged with other accessories.)
(3) Strip the sheath of the power cord, twist the wire ends, and connect them to the Power Connector.
(4) Reattach the Power Connector.
Recommended Driver SZF 1-0.6x3.5 (1204517)
Recommended Pin
Terminals
AI 0.75-8GY (3200519)
AI 1-8RD (3200030)
AI 1.5-8BK (3200043)
AI 2.5-8BU (3200522)
Recommended Pin
Terminal Crimp Tool
CRIMPFOX ZA3 (1201882)
• Be sure to remove the connector from the ST unit prior to starting wiring. Failure
to do so may cause an electric shock.
• The temperature rating of field installed conductors: 75°C only.
• Use a slot screwdriver (Size 0.6 X 3.5) to tighten the terminal screws.
The torque required to tighten these screws is 0.5 to 0.6N
•m [5-7Lb•In.].
• Do not solder the cable connection.
• Be sure to twist the power cords together, up to the power connector.
Power
Connector
(Socket)
Right side
Power Connector (Plug)
(The drawing on the left
is the ST-3300 Series.)